Introduction » YOKOMO » Yokomo YD-4 AWD Drift Car (w/FCD1.5)


Yokomo YD-4 AWD Drift Car (w/FCD1.5)


out of stock


Product no.: 004110
normal price € 349.0 (9,074.0 Kč)
our price without Tax : € 276.9 (7,198.3 Kč)
our price including Tax (21 %):
€ 335.0 (8,710.0 Kč)

into the basket:

Full specifications

 Yokomo   YD-4 Europe version


"Stylish" driving style requires the chassis to be controllable under all conditions. Tanso (Single/Solo) runs that are performed at your near limits and Tsuiso (Tandem/Battle) runs where you aim to match your opponent all require you to put your machine under your control, which becomes a key point in improved performance, says R&D chief and Team Yokomo Drift Leader Matsuzaki Hayato. Placing the center of mass low, and towards the center of the chassis allows for quick initiations and drift angle stability, while the drift specific suspension and steering rack (Steel Construction) allows for more line tracing freedom.

The best feature of YD-4 is the professional competition machine which allows to get the podium in stock configuration without any hop-up options!

The front suspension utilizes a rigid ‘H’ arm. It increases steering response and line trace accuracy, preferred by expert drivers. Standard ‘H’ arm type suspension tends to have steering angle limitations and clearance issues compared to an ‘I’ arm. The YD-4 resolves this issue with an exclusive suspension arm that has a compact hub carrier. Its 55 degree maximum steering angle is the highest in its class.

The steering block is a narrow scrub type to achieve neutral steering feel. The block also has added KPI for movement close to that of an actual car to achieve a more realistic drifting style.

The slide steering rack system, capable of precise Ackermann geometry while holding a large steering angle, is precision made steel construction, supported by bearings on eccentric posts for fine clearance adjustments and limits wheel play to a minimum while steering.

By gathering most of the mass towards the center of the chassis, excess momentum while pivoting is reduced. This allows for sharp drift initiations and transitions, while maintaining high stability and control-ability in a drift. In addition to the pictured shorty LiPo, A simple change of the battery holder location allows for use of a standard size LiPo (Square/Round).

Although it uses gears common to the Drift Package series in the front and rear, the gear cases have been redesigned to allow the center of mass to be dropped by 2mm. (When compared to the DP) The shock tower also sits lower but the new body post design allows for the rear shocks to be mounted vertically. The shock spring retainers are also redesigned to allow for long springs. A sharp yet supple driving style is achievable.



  • High efficiency front-mid shaft drive 4wd
  • 4-Wheel independent double wishbone suspention
  • High performance oil dampers
  • 3.0mm high rigidity carbon graphite chassis
  • 2.5mm carbon graphite upper deck
  • 4.0mm high rigidity shock tower
  • New LCG design gear box
  • New LCG design floating motor mount
  • Slide rack steering system
  • New YD-4 front one-way diff
  • FCD ×1.5 Rear solid axle (Euro)
  • New 57 degree universal drive shaft
  • New design narrow scrub nuckle
  • Large size rear diffuser



Total length

434mm (Includingdiffuser)

Total width


Wheel base width

255mm (Adjustable)

Internal gearing ratio


Full equipped weight



Assembly kit 
running what you need for: 2-channel Radio set (transmitter-receiver speed controller servo), battery (Li-po 2 cell), charger, tire, wheel, motor, body, polycarbonate paint


More information about the chassis can be found here: